2000-A2-GB20-10 - 157 - February 20043. If DHCP Relay is not enabled, the IAD displays this prompt:DHCP Server is currently DISABLEDEnter E to Enable, D to Disable:Type E to enable DHCP Server, to type D to disable DHCP Server.Proceed to Step 1 in the next section.Enablingand Dis-ablingCheckingfor Addi-tionalDHCP Serv-ersWhen the IAD boots, the internal DHCP server may be configured tocheck for additional DHCP servers on the LAN, and disable IAD-basedDHCP service.To enable or disable checking for external DHCP servers:1. Type D to select Enable/Disable Checking for Additional DHCPServers.2. The IAD displays this prompt:Checking for additional DHCP Servers is currentlyDISABLEDEnter E to Enable, D to Disable:Type E to enable checking, or D to disable checking.Proceed to Step 1 in the next section.Configur-ing DHCPServerParametersTo configure DHCP Server parameters, type I on the DHCP ServerConfiguration menu, or continue from the previous section.1. The IAD displays the gateway address and prompt:Current Gateway address = 0.0.0.0Enter new Gateway IP address:Type the IP address of the gateway and press Enter. If there is nogateway available, type the address of the Ethernet port.2. The IAD displays the current DNS Server address and a prompt:Current DNS Server address = 0.0.0.0Enter 255.255.255.255 to use the DNS Server assignedfrom another port.Enter new DNS Server IP address:Type the new DNS Server address, or type 255.255.255.255 to usea DNS Server assigned from another port. Press Enter to continue.3. The IAD displays the current NetBIOS Server address and prompt:Current NetBIOS Server address = 0.0.0.0Enter new NetBIOS Server IP address:4. Type the IP address of the new NetBIOS Server and press Enter.5. The IAD prompts you for the subnet mask:Current Subnet Mask = 255.255.255.0Enter new Subnet Mask:Type the new subnet mask and press Enter.6. The IAD displays the current domain name and prompt:Current Domain name =Enter new Domain Name:Type the new domain name and press Enter.
