2000-A2-GB20-10 - 193 - February 2004Figure 12–3. Clear Network Statistics MenuTo permanently reset statistics for a specific protocol, type the option.The IAD immediately resets all statistics for the specified protocol, anddisplays the menu.Continue resetting network statistics, or press Escape to return to theNetwork Statistics menu.InterfaceStatisticsReportsType I on the Reports menu to display interface statistics reports. TheInterface Statistics menu contains commands to display information aboutthe packets handled between layer 2 and layer 3 on a per port basis, andto clear statistics for specific protocols.To display specific interface statistics, first select an interface andoptionally a port. The IAD then displays the report, as shown in thesesteps:1. The IAD displays the interfaces on this IAD, and a prompt:Available Interfaces:1. T1/E12. 10/100BaseT Ethernet0. (Abort)Type the number of the interface.2. If there is more than one port, the IAD displays the port list and prompt:Port DLCI Encapsulation1 18 Proprietary Voice DLCISelect Port: [1-8]Type the port number and press Enter.3. The IAD displays the Interface Statistics menu:Figure 12–4. Interface Statistics Menu (all options shown)To display a specific report, type the option.C. Clear ICMP StatisticsG. Clear IGMP StatisticsI. Clear IP StatisticsP. Clear PIM StatisticsT. Clear TCP StatisticsU. Clear UDP StatisticsNOTE The commands that display on the Network Statistics menuvary, based on the WAN module and configuration of the IAD.A. Display ARP StatisticsI. Display Interface StatisticsB. Display Bridge StatisticsD. Display DLCI StatisticsZ. Clear a StatisticZ. Clear ATM PVC StatisticsOption D displays “PVCStatistics” when IAD isconfigured for ATM.(Ethernet only)
