2000-A2-GB20-10 - 56 - February 20041. Type 1 (Configure Physical Interface) to display the G2237 xDSLConfiguration menu.Figure 4–8. G2237 xDSL Configuration menuSelecting the xDSL Interface Type1. Type 1 to display the G2237 xDSL Interface Type menu.Figure 4–9. G2237 xDSL Configuration menuType the option to select G.SHDSL Annex A for operation in U.S.,Annex B for operation in Europe, or SDSL.2. The IAD sets the interface type and displays the menu.3. Press Escape to return to the xDSL Configuration menu.4. Reset the IAD (page 14) when you finish WAN configuration.Configur-ing theG.SHDSLInterfaceThe tasks described in this section all begin on the G2237 xDSLConfiguration menu. The tasks are described so you can proceed throughthem sequentially. You should review and update each of these options asnecessary, and reset the IAD when you finish WAN configuration.To configure the G.SHDSL interface, type 2 (Configure Physical Interface)on the WAN Configuration menu to display the G2237 xDSL Configurationmenu:******************************************G2237 xDSL Configuration******************************************Current Interface Type is: G.SHDSL-A.Mode: CPE, Rate Mode: FIXED,Line Rate: 88K, Debug: DISABLED.1. Select xDSL Interface Type2. Select CPE/CO Mode3. Enable/Disable Adaptive Rate Mode4. Select Line RateD. Enable/Disable G2237 xDSL Debug Messages********************************************Configure xDSL Interface Type*******************************************Current xDSL Interface Type: G.SHDSL1. G.SHDSL Annex A (U.S.)2. G.SHDSL Annex B (Europe)3. SDSLLAN LINK LAN ACT WAN LINK VOICEPOWERJF2104JF2104iJF2108This section is only for configuring the G.SHDSL (Annex A orAnnex B) WAN interface, available on the JF2104, JF2108,and JF2104i.
