2000-A2-GB20-10 - 60 - February 2004Configuring the Adaptive Rate Mode1. Type 3 to display the SDSL Rate Mode menu.Figure 4–15. Configure SDSL Rate Mode MenuType the option to select the rate mode.If you set the rate mode to Nokia Auto-Cycle, you need to enter a linerate value.2. The IAD sets the rate mode and displays the menu.3. Press Escape to return to the SDSL Configuration Menu.Selecting the Line Rate1. Type 4 to display the current line rate and a prompt:Line Rate is currently: 88 KbpsEnter xDSL Line Rate:Type a line rate value (between 64 Kbps and 2320 Kbps), which mustbe a value evenly divisible by 8.2. The IAD sets the rate and displays the xDSL Configuration Menu.3. Reset the IAD (page 14) when you finish WAN configuration.Enabling and Disabling xDSL Debug MessagesConfigur-ing theSDSL Inter-faceThe tasks described in this section all begin on the SDSL Configurationmenu. You should review and update each of these options as necessary,and reset the IAD when you finish WAN configuration.To configure the SDSL interface, Type 2 (Configure Physical Interface) onthe WAN Configuration menu to display the SDSL Configuration menu:**************************************************Configure SDSL Rate Mode**************************************************Current Rate Mode: AUTO-BAUD1. Fixed2. Auto-Baud3. Lucent Sync Delay - Fixed4. Lucent Sync Delay - Auto-Baud5. Nokia Auto-CycleNOTE Option D, Enable/Disable G2237 xDSL Debug Messages, isreserved for Paradyne network engineers.LAN LINK LAN ACT WAN LINK VOICEPOWERJF2304JF2308JF2316This section is for configuring the SDSL WAN interface on theJF2304, JF2308 or JF2316.