2000-A2-GB20-10 - 65 - February 2004Type the option corresponding to the ATM standard.6. The IAD sets the standard you select and displays the menu.7. Reset the IAD (page 14) when you finish WAN configuration.Using the Debug MenuSetting theInterface toT1 or E1To determine the WAN interface setting, or to switch the WAN interface foruse in a T1 (North American) or E1 environment, type 5 (Configure WAN)on the Main menu to display the WAN Configuration menu for T1/E.Figure 4–21. WAN Configuration Menu for T1/E11. Type 2 to select Configure Physical Interface.2. The IAD displays the T1 (Figure 4–22) or E1 Configuration menu(Figure 4–23), depending on how your IAD is configured:Figure 4–22. T1 Configuration MenuNOTE Option D—ADSL Debug Messages—is reserved forParadyne network engineers.LAN LINK LAN ACT WAN LINK VOICEPOWERJF2208JF2216This section is for configuring the IAD to use the T1 or E1WAN interface on the JF2208 or JF2216 IAD.*****************************************WAN Configuration Menu*****************************************Configuring T1/E11. Configure Datalink Protocol2. Configure Physical Interface3. Configure PVCs4. Configure ATM Options*******************************************T1 Configuration Menu*******************************************1. Select Frame Mode (D4 or ESF)2. Select Transmit Line Build Out4. Select B8ZS or AMI5. Configure Loopback6. Configure Transmit Channels7. Configure Receive Channels8. Configure Transmit Clock Source9. Change to E1 Mode
