2000-A2-GB20-10 - 54 - February 2004Figure 4–6. WAN Configuration Menu (Frame Relay)3. Reset the IAD (page 14) when you finish WAN configuration.Setting UpTDM VoiceTDM Voice allows you to set up data and voice circuits on channelized T1circuits. You may set up TDM Voice only, or TDM Voice + ATM, or TDMVoice + Frame Relay.To set up TDM voice on channelized IADs:1. On the WAN Configuration menu, type 1 to select Configure DatalinkProtocol.2. The IAD displays the WAN Datalink Protocol Configuration menu,identifying the current datalink protocol just below the banner.Figure 4–7. WAN Datalink Protocol Configuration Menu3. Type E to select TDM Voice.4. The IAD displays the current channel configuration and prompts youfor the number of voice channels to allocate:Current configuration table is:Ch Configuration-- --------------------------------------------1 VOICE Undefined Mode - Linked to POTS port 12 VOICE Undefined Mode - Linked to POTS port 23 VOICE Undefined Mode - Linked to POTS port 3...24 VOICE Undefined Mode - Linked to POTS port 24*****************************************WAN Configuration Menu*****************************************Configuring G2237 xDSL1. Configure Datalink Protocol2. Configure Physical Interface3. Configure DLCIs4. Configure FR OptionsOptions 3 and 4display Frame Relayconfiguration optionsLAN LINK LAN ACT WAN LINK VOICEPOWEROption E—TDM Voice is displayed only on channelized IADs.*********************************************WAN Datalink Protocol Configuration Menu*********************************************Current DataLink Protocol: Frame Relay6. ATM7. Frame RelayE. TDM VoiceThis option applies only to IADswith channelized T1 WAN ports.
