2000-A2-GB20-10 - 64 - February 2004Enter SDSL Auto Cycle Speed Entry to Configure(1..14):Type the value of the entry to configure.3. The IAD prompts for the data rate:Enter SDSL Data Rate (kbps):Type the data rate (144 kbps to 2320 kbps, evenly divisible by 8000).4. The IAD saves the configuration and displays the SDSL Configurationmenu.Using the Debug MenuConfigur-ing theADSL Inter-faceThe tasks described in this section all begin on the ADSL Configurationmenu. You should review and update each of these options as necessary,and reset the IAD when you finish WAN configuration.To configure the ADSL interface, Type 2 (Configure Physical Interface) onthe WAN Configuration menu to display the ADSL Configuration menu:Figure 4–19. G7070 ADSL ATU-R Configuration Menu5. Type 1 to select Set ADSL Standard. The IAD displays the ADSLStandard menu.Figure 4–20. ADSL Standard to use for Startup MenuNOTE Commands in option D—SDSL Debug Menu—are reservedfor Paradyne network engineers.LAN LINK LAN ACT WAN LINK VOICEPOWERJF2004JF2008JF2004iThis section is only for configuring the ADSL WAN interfaceon the JF2004, JF2008 and JF2004i.*****************************************G7070 ADSL ATU-R Configuration*****************************************1. Set ADSL StandardD. Enable/Disable ADSL Debug Messages*****************************************ADSL Standard to use for Startup*****************************************Current ADSL Standard: Multi-Mode1. T1.4132. G.LITE3. G.DMT4. Alcatel 1.45. Multi-Mode6. ADI7. Alcatel