2000-A2-GB20-10 - 156 - February 2004The DHCPServerConfigur-ation MenuThe DHCP Server commands are all displayed on the DHCP ServerConfiguration menu (displayed by typing D on the Main menu).Tasks in this chapter are all described beginning at this menu:Figure 9–1. DHCP Server Configuration MenuYou may sign on as Supervisor or Network Manager to configure the IADfor use as a DHCP Server. Options that display in the DHCP ServerConfiguration menu are the same for both security levels.UsingDHCPDebuggingMessagesThe commands in option B, Enable/Disable DHCP Debug Messages, arereserved for use by Paradyne network engineers.Enablingand Dis-ablingDHCPServerWhen you enable DHCP Server, the IAD sequentially displays andprocesses the required configuration commands beginning with EnableDHCP Server.To enable or disable DHCP Server, follow these steps:1. Type E to select Enable/Disable DHCP.2. If DHCP Relay is enabled, the IAD displays this prompt:DHCP Server and DHCP Relay cannot both be enabled!Do you wish to disable DHCP Relay? (N)Type Y to disable DHCP Relay and enable DHCP Server, and proceedto step 4.*******************************************DHCP Server Configuration Menu*******************************************E. Enable/Disable DHCPH. Enable/Disable Checking Additional DHCP ServersB. Enable/Disable DHCP Debug MessagesI. Configure DHCP Server ParametersP. Configure DHCP Address Range PoolC. Configure DHCP Client EntryF. Display DHCP ConfigurationS. Display DHCP Server StatisticsA. Display DHCP Server Assigned AddressesU. Display DHCP Server Unassigned AddressesD. Display DHCP Entry DetailsX. Delete A DHCP Client EntryY. Delete A DHCP Assignment EntryNOTE Be sure to reset the IAD (page 14) when after configuring theIAD as a DHCP Server. Resetting the IAD causes theconfiguration changes to take effect.
