2000-A2-GB20-10 - 34 - February 2004Setting upYour LANConnectionThe IAD LAN port may be set for full duplex Ethernet operation if your IADis set up as a router. Full duplex mode allows simultaneous transmissionand receipt of Ethernet packets.On the Main menu, type 6 (Configure LAN) to display the LANConfiguration menu.Figure 3–5. LAN Configuration MenuSelecting the ConnectionIf more than one connection is defined, the IAD prompts you to specify theport number. Type the number of the port, select enable or disable andpress Enter.Establishing LAN Speed and Duplex Mode1. Type the option number of the speed and duplex mode.2. The IAD saves the configuration. Press Escape to return to the Mainmenu.3. Reset the IAD (page 14) for changes to take effect.You can display the current LAN settings using the Display CurrentConfiguration command in the Reports menu (page 182).*******************************************LAN Configuration Menu*******************************************1. 10 Mbps Full Duplex2. 10 Mbps Half Duplex3. 100 Mbps Full Duplex4. 100 Mbps Half Duplex5. Auto Negotiate the Speed, Full Duplex6. Auto Negotiate the Speed, Half Duplex7. Auto Negotiate Speed & Full/Half Duplex Mode8. Display MII & FEC RegistersNOTE Full duplex Ethernet operation is controlled by the switch. Ifthe switch is set to full duplex, you may enable it in the IAD. Ifyou enable full duplex Ethernet in the IAD when the switch isoperating in normal half duplex mode, your IAD will notcommunicate on the LAN.
