2000-A2-GB20-10 - 36 - February 2004Using Trace RouteUse Trace Route to trace the network route to a specified host. To runTrace Route, follow these steps:1. Type X on the Utilities menu and press Enter.2. Type the IP address or host name to trace and press Enter. If you entera host name, you must enter the domain name with the host name. Forexample, mycomputer.mydomain.com.The IAD displays each hop, as shown in the following sample report:Trace Route Results to 91.1.1.11 5ms 91.1.1.1Setting up the USI PortTo set up the USI port, follow these steps:1. Type U on the Utilities menu and press Enter.2. The IAD displays the following:Enter 1 to enable a USI module as a uart interfaceon slot 1Enter 0 to make a USI module a RS530 interface onany slot->(current=0)3. Type 1 to select V.35. Type 0 to select RS-530.4. Reset the IAD (page 14) to use the new USI settings. Voltage levels forV.35 and RS-530 are different. Be sure to use the appropriate cable forthe protocol you choose.Configuring the Console Baud RateTo set the console port baud rate (for connecting to Hyperterminal via aserial cable), follow these steps:1. Type Z on the Utilities menu to display the following menu:2. Type 0 to reset the baud rate to the default (19200 bps), or select aspecific baud rate and press Enter.3. Reset the IAD (page 14) to use the new console port settings. Be surethe terminal settings are the same as the console port settings.Configuring the Console Timeout PeriodTo maintain security, you can set the amount of time a console or Telnetsession remains alive before termination due to inactivity. To set thetimeout period, follow these steps:LAN LINK LAN ACT WAN LINK VOICEPOWER16/24-Port The USI port is available only on 16/24-port IADs.Current Console Baud Rate is: 19200Enter New Console Baud Rate0. Unset (use Default)1. 96002. 192003. 384004. 576005. 115200
