2000-A2-GB20-10 - 55 - February 2004Enter number of voice channels desired for this chunk:Type the number of voice channels.5. The IAD asks you for the starting channel:Enter the starting channel of this voice channelchunk:Type the starting channel number for this chunk of circuits.6. The IAD asks if you want to allocate more circuits:Do you want to continue allocating new chunks?[y/n]:7. Type Y to repeat these steps, or N to continue.8. The IAD asks you for the number of data channels to allocate:Enter the number of data channels desired:Type the number of voice channels.9. The IAD asks you for the starting channel:Enter starting channel of this voice channel chunk:Type the starting channel number for this chunk of circuits.10. The IAD asks if you want to allocate more circuits:Do you want to continue allocating new chunks?[y/n]:11. Type Y to repeat these steps, or N to continue.12. The IAD asks you to select the signaling protocol for voice:Enter the signaling protocol on voice channels:1. Loop Start2. Ground Start (Opt. Selection-Not Implemented)3. Immediate Start (Opt. Selection-Not Implemented)4. Wink Start (Opt. Selection-Not Implemented)Enter Selection:Type the option for the signaling protocol and press Enter.13. If you assigned one or more data channels, the IAD asks you to selectthe datalink protocol for those channels:Enter the protocol on the selected data channels:6. ATM7. Frame RelayEnter Selection:Type 6 for ATM or 7 for Frame Relay.14. The IAD displays the current datalink protocol, saves the selection anddisplays the current channel settings. Press Escape to return to themenu and continue WAN configuration.Selectingthe Physi-cal Inter-faceOn all IADs except the JF2100 series, the WAN interface is fixed. OnJF2100 IADs, you may select G.SHDSL or SDSL as the interface.LAN LINK LAN ACT WAN LINK VOICEPOWERJF2104JF2104iJF2108This section is for selecting either G.SHDSL or SDSL as theWAN interface on the JF2104, JF2104i and JF2108.
