2000-A2-GB20-10 - 125 - February 2004Configur-ing Span-ning TreeHello TimeTo set the Spanning Tree hello time (a value between 1 and 10 seconds—default 2), follow these steps:1. Type H on the Bridge Configuration menu to select Configure SpanningTree Hello Time.2. The IAD displays the following prompt:Enter Bridge Hello Time(1..10): (2)Type the priority value and press Enter.3. The IAD updates the configuration.4. Press any key to return to the Bridge Configuration menu and continuewith other configuration tasks.5. Reset the IAD (page 14) when you finish bridge configuration.Configur-ing Span-ning TreeMaximumAgeTo set the Spanning Tree maximum age, (a value between 6-40seconds—default 20), follow these steps:1. Type S on the Bridge Configuration menu to select Configure SpanningTree Max Age.2. The IAD displays the following prompt:Enter Spanning Tree Max Age (6..40): (20)Type the maximum age value and press Enter.3. The IAD updates the configuration.4. Press any key to return to the Bridge Configuration menu and continuewith other configuration tasks.5. Reset the IAD (page 14) when you finish bridge configuration.Configur-ing Span-ning TreeForwardDelayTo set the Spanning Tree forward delay (a value between 4-30 seconds—default 15):1. Type F on the Bridge Configuration menu to select Configure SpanningTree Forward Delay.2. The IAD displays the following prompt:Enter Spanning Tree Forward Delay (4..30): (15)Type the forward delay value and press Enter.3. The IAD updates the configuration.4. Press any key to return to the Bridge Configuration menu and continuewith other configuration tasks.5. Reset the IAD (page 14) when you finish bridge configuration.Configur-ing Span-ning TreePath CostWhen there are multiple paths to the Root Bridge, the Spanning Treealgorithm selects the port with the lowest total path cost as the route port.To set the Spanning Tree path cost (a value between 1 and 65,535—default 32,768), follow these steps:1. Type c on the Bridge Configuration menu to select Configure SpanningTree Path Cost.2. The IAD displays the interfaces available on this IAD, and a prompt:
