2000-A2-GB20-10 - 41 - February 2004Using theDebugMenuThe Debug menu contains commands to set various debugging options.Debugging should only be enabled specifically during a debugging ormonitoring session, and disabled when the session is complete. Enablingmultiple debugging options simultaneously slows IAD performance.Debugging options may be enabled and disabled without resetting theIAD. To display the Debug menu, type G on the Utilities menu.Figure 3–9. Debug MenuTo perform a task, type the option and proceed to the appropriate section,following.Setting the Ethernet MAC AddressTo modify the Ethernet MAC address, perform these steps:1. Type M on the Debug menu. The IAD displays the following message:This will change the factory setting for the ENETMac Address.Are you sure?2. Type Y to proceed, or any other character to abort.When you proceed, the IAD displays the current MAC address for theEthernet port and prompts for a new one:Current Ethernet Address= 00-E0-75-1C-0E-18New MAC Address = *-**-**-**-**-**3. Type the new MAC address. Press Escape any time to abort this task.4. Reset the IAD (page 14) for the new MAC address to take effect.Enabling and Disabling PPP Debug ModeWhen you enable PPP debugging, the IAD displays PPP debugmessages. To enable or disable PPP debugging, follow these steps:1. Type E on the Debug menu. The IAD displays the PPP debug status:PPP Debug Mode is currently DISABLED2. Type E to enable PPP debugging, or type D to disable it.The IAD sets PPP debug mode to the setting you entered, and displaysthe Debug menu.NOTE Debugging commands are reserved for use by Paradynenetwork engineers.***************************************************Debug Menu***************************************************M. Set Ethernet MACE. Enable/Disable PPP debug modeS. Enable/Disable STP debug modeI. Enable/Disable DHCP Client debug modeQ. Display Error Dump
