Parameters A - 3F7 Parameter ListTable A.1 F7 Parameter ListParameterNo.Parameter NameDigital Operator Display Description SettingRangeFactorySettingControl MethodV/F V/Fw/PGOpenLoopVectorFluxVectorInitializationA1-00Language SelectionSelect LanguageLanguage selection for the Digital Operator.This parameter is not reset to the factory setting by A1-03.0: English1: Japanese2: Deutsch3: Francais4: Italiano5: Espanol6: Portugues0 to 6 0 A A A AA1-01Access Level SelectionAccess LevelSelects which parameters are accessible via the Digital Operator.0: Operation Only1: User Level (only available if A2 parameters have been set)2: Advanced Level0 to 2 2 A A A AA1-02 Control Method SelectionControl MethodSelects the Control Method of the Drive.0: V/F control without PG1: V/F control with PG2: Open Loop Vector3: Flux Vector (Closed Loop Vector)0 to 3 2 Q Q Q QA1-03 Initialize ParametersInit ParametersUsed to return all parameters to their factory or user defaultsettings. (Initializes and then returns A1-03 to zero.)0: No Initialize1110: User Initialize (The user must first set their own parametervalues and then store them using parameter o2-03.)2220: 2-Wire Initialization3330: 3-Wire Initialization0 to3330 0 A A A AA1-04 Password 1Enter PasswordWhen the value set into A1-04 does NOT match the value set intoA1-05, parameters A1-01 thru A1-03 and A2-01 thru A2-32 cannotbe changed. All other parameters as determined by A1-01 can bechanged. Parameter A1-05 can be accessed by pressing the MENUkey while holding the RESET key.0 to 9999 0 A A A AA1-05 Password 2Select Password 0 to 9999 0 A A A AUser ParametersA2-01 User Parameter 1User Param 1Selects the parameters to be available in the User Access Level(A1-01 = 1). These parameters are not related to the User Initializefunction.b1-01too3-02– A A A AA2-02 User Parameter 2User Param 2 – A A A AA2-03 User Parameter 3User Param 3 – A A A AA2-04 User Parameter 4User Param 4 – A A A AA2-05 User Parameter 5User Param 5 – A A A AA2-06 User Parameter 6User Param 6 – A A A AA2-07 User Parameter 7User Param 7 – A A A AA2-08 User Parameter 8User Param 8 – A A A AA2-09 User Parameter 9User Param 9 – A A A ADenotes that parameter can be changed when the Drive is running.