Parameters A - 38F7 Monitor List Table A.2 F7 Monitor ListParameterNo.Parameter NameDigital Operator Display Description Display UnitsMonitorU1-01 Frequency ReferenceFrequency RefFrequency reference (speed command) monitor when inREMOTE mode, frequency reference (speed command)setting location when in local mode or b1-01 = 0.Set by o1-03.U1-02 Output FrequencyOutput Freq Output frequency Set by o1-03.U1-03 Output CurrentOutput Current Output current 0.01AU1-04 Control MethodControl MethodControl method set in A1-02.0 = V/F without PG1 = V/F with PG2 = Open Loop Vector3 = Flux Vector-U1-05 Motor SpeedMotor Speed Motor speed feedback Set by o1-03.U1-06 Output VoltageOutput Voltage Output voltage 0.1VacU1-07 DC Bus VoltageDC Bus Voltage DC Bus Voltage 1VdcU1-08 Output PowerOutput kWatts Output power 0.1kWU1-09 Torque ReferenceTorque Reference Torque reference 0.1%U1-10 Input Terminal StatusInput Term StsInput terminal status-U1-11 Output Terminal StatusOutput Term StsOutput terminal status.-01: FWD. run(Terminal S1) is ON.1: REV. run(Terminal S2) is ON.1: Multi-function input 1(Terminal S3) is ON.1: Multi-function input 2(Terminal S4) is ON.1: Multi-function input 3(Terminal S5) is ON.1: Multi-function input 4(Terminal S6) is ON.1: Multi-function input 5(Terminal S7) is ON.1: Multi-function input 6(Terminal S8) is ON.0 0 0 0 0 0 01: Multi-function Output 1(Terminal M1-M2) is ON.1: Multi-function Output 2(Terminal M3-M4) is ON.1: Multi-function Output 3(Terminal M5-M6) is ON.0: Not used1: Fault output(Terminal MA-MB-MC) isON.0 0 0 0 0 0 0 0