Physical Installation 1 - 13Removing and Attaching the Terminal CoverRemove the terminal cover to connect cables to the control circuit and main circuit terminals. Removing the Terminal Cover Models CIMR-F7U20P4 thru 2018 and 40P4 thru 4018Loosen the screw at the bottom of the terminal cover, press in on the sides of the terminal cover in the directions of arrows 1,and then lift up on the terminal in the direction of arrow 2.Fig 1.9 Removing the Terminal Cover Models CIMR-F7U2022 thru 2110 and 4030 thru 4300Loosen the screws on the left and right at the top of the terminal cover, pull down the terminal cover in the direction of arrow1, and then lift up on the terminal cover in the direction of arrow 2.Fig 1.10 Removing the Terminal Cover Attaching the Terminal CoverAfter wiring the terminal block, attach the terminal cover by reversing the removal procedure.For Models CIMR-F7U2018/4018 and smaller, insert the tab on the top of the terminal cover into the groove on the Drive, andpress in on the bottom of the terminal cover until it clicks into place.For Drives CIMR-F7U2022/4030 and larger, insert the tab on the top of the terminal cover into the groove on the Drive, andsecure the terminal cover by lifting it up toward the top of the Drive.11212