Physical Installation 1 - 16 Models CIMR-F7U2022 thru 2110 and 4030 thru 4300For Models CIMR-F7U2022/4030 and larger, remove the terminal cover and then use the following procedures to remove theDigital Operator and front cover. Removing the Digital OperatorUse the same procedure for Models CIMR-F7U20P4 thru 2018 and 40P4 thru 4018. Removing the Front CoverLoosen all screws on the front cover. Lift up at the location labelled 1 at the top of the control circuit terminal card and movein the direction of arrow 2.Fig 1.14 Removing the Front Cover Mounting the Front CoverAttach the front cover by reversing the procedure to remove it.1. Confirm that the Digital Operator is not mounted on the front cover. If the cover is attached while the Digital Operator ismounted to it, the Digital Operator may malfunction due to improper mating with its connector.2. Insert the tab on the top of the front cover into the slot on the Drive and press in on the cover until it clicks into place on theDrive. Mounting the Digital OperatorUse the same procedure for Models CIMR-F7U20P4 thru 2018 and 40P4 thru 4018.12
