Digital Operator 3 - 4Drive Mode IndicatorsThe definition of the Drive mode indicators are shown in Table 3.2. REMOTE Sequence (SEQ) IndicatorThe status of the “REMOTE” Sequence (SEQ) indicator is shown in Table 3.3. This indicator is always “Off” when the Driveis in the “LOCAL” mode. When the Drive is in the “REMOTE” mode, the SEQ indicator status is dependent on the setting ofparameter b1-02 (Run Command Selection). See Table 3.3.Table 3.2 Drive Mode IndicatorsIndicator DefinitionFWD Lit when a forward run command is input.REV Lit when a reverse run command is input.REMOTE SEQ See Table 3.3.REMOTE REF See Table 3.4.ALARM Lit when a fault has occurred. Flashes when an Alarm has occurred.Table 3.3 REMOTE Sequence (SEQ) IndicatorIndicator Status ConditionOnParameter b1-02 (Run Command Selection) is set to terminal strip, communications, or an optionboard as indicated below:b1-02=1 (Terminals)=2 (Communications)=3 (Option PCB)Off Parameter b1-02 (Run Command Selection) is set to Digital Operator as indicated below:b1-02=0 (Operator)