Digital Operator 3 - 6Drive Main MenusThe Drive’s parameters and monitoring functions are organized into groups called menus that make it easier to read and setparameters. The Drive is equipped with five menus. The five menus and their primary functions are shown in Table 3.7.Table 3.7 Drive Main MenusMain Menu Primary FunctionsOperation- DRIVE -The Drive can run in this menu.Use this menu for monitoring values such as frequency reference or output current, displaying faulthistory or displaying the fault traces.Quick Setting- QUICK -The Drive can be programmed in this menu.Use this menu to set/read the most commonly used parameters.Programming- ADV -The Drive can be programmed in this menu or parameters can be copied into the Digital Operator.Use this menu to set/read every parameter.Modified Constants- VERIFY -The Drive can be programmed in this menu.Use this menu to set/read the parameters that have been modified from their factory default settings.Auto-Tuning- A.TUNE -The Drive can be programmed in this menu.Use this menu to Auto-Tune the Drive in order to optimize motor control.The motor parameters are calculated and set automatically after successfully completing Auto-Tuning.