Digital Operator 3 - 3Digital Operator KeysThe names and functions of the Digital Operator Keys are described in Table 3.1.Table 3.1 Digital Operator KeysKey Name FunctionLOCAL / REMOTE• Switches between operation via the Digital Operator (LOCAL) and the settings inparameter b1-01 (Frequency Reference Selection) and b1-02 (Run CommandSelection) (REMOTE).• This key can be enabled or disabled by the setting in parameter o2-01.• The Drive must be in a stopped condition before it can be transferred to “LOCAL”or “REMOTE” mode.MENU• Scrolls through the five main menus:• Operation (-DRIVE-), Quick Setting (-QUICK-), Programming (-ADV-),Modified Constants (-VERIFY-), and Auto-Tuning (-A.TUNE-).ESCAPE • Returns to the previous display, before the DATA/ENTER key waspressed.JOG • Enables jog operation when the Drive is being operated from the DigitalOperator (LOCAL).FWD / REV • Selects the rotation direction of the motor when the Drive is being operatedfrom the Digital Operator (LOCAL).INCREASE • Increases parameter numbers and set values.• Used to move to the next item or data value.DECREASE • Decreases parameter numbers and set values.• Used to move to the previous item or data value.SHIFT / RESET• Selects the digit to be changed. The selected digit will blink.• Also resets the Drive when a fault has occurred. The run command must beremoved before the reset command will be accepted.DATA / ENTER • Enter menus and parameters as well as to set values.RUN • Starts Drive operation when the Drive is being controlled by the Digital Operator(LOCAL).STOP Key• Stops Drive operation.• This key can be enabled or disabled when operating from the externalterminal or communications by setting user parameter o2-02.