Chapter 22-22F-2-727) Close the cassette upper right cover and the cassette lower right cover.8) Attach the card reader [1] and the card reader base plate [2].- 1 toothed washer [3]- 1 screw (TP; M4X8) [4]F-2-739) Fix the relay cable [1] of the card reader in place.- 1 edge saddle [2]- 1 wire saddle [3]F-2-7410) Connect the relay cable [1] that is connected in the step 5) with the relaycable [2] of the card reader.F-2-7511) Fit the 2 bosses [1] to attach the card reader [2].- 1 toothed washer [3]- 1 screw (TP; M4X25) [4]F-2-7612) Plug the power cable (for outlet) into the outlet.13) Turn ON the switch of the main power.14) Enter the card number (1 through 2001) to use by selecting the followingin service mode:COPIER > FUNCTION > INSTALL > CARD- Enter the smallest number among the cards used by user- 1000 cards from the input number are usable15) Turn OFF the power supply following the shutdown sequence.16) Insert the usable card (that is registered to use) to check that it is standbystate.2.8.5 Installation Procedure in the imageWAREAccounting Manager (hereinafter referred to iWAM)Environment 0013-8497Color iR C3380G / Color iR C2880G / Color iR C3380i / Color iR C3380 /Color iR C2880i / Color iR C2880 / iR C3480 / iR C3480i / iR C3080 / iRC3080i / iR C25501) Check to see that 'ID00000001 to ID00001000' have been created in '[Ad-ditional Functions] > [System Settings] > [Dep ID Mangement] > [Regis-tor Dept.ID/Password] / [Page Totals]'. (In the case of entering '1' as thefirst number in 'Service Mode > COPIER > FUNCTION > INSTALL >CARD')2) Press [Reset] to exit from [Additional Functions].3) Select [Additional Functions] > [System Settings] > [Network Settings] >[TCP/IP Settings] > [IP Address Settings], and then make the setting of[IP Address], [Gateway Address], [Subnet Mask] according to the userenvironment.4) Press [Reset] to exit from [Additional Functions].5)[1][2][4][3][1][2][3]Take care not to nip the harness.[1] [2][1][3] [4][2]
