Chapter 1717-5017.4.2 FEEDER17.4.2.1 FEEDER Table 0013-8997Color iR C3380G / Color iR C2880G / Color iR C3380i / Color iR C3380 / Color iR C2880i / Color iR C2880 / iR C3480 / iR C3480i / iR C3080 / iR C3080i / iRC2550*1; Displayed only in the case of the machine with DADF T-17-3917.4.3 SORTER17.4.3.1 SORTER Table 0014-5586Color iR C3380G / Color iR C2880G / Color iR C3380i / Color iR C3380 / Color iR C2880i / Color iR C2880 / iR C3480 / iR C3480i / iR C3080 / iR C3080i / iRC2550T-17-40ACS-CNT - ACS-CNT (Used to adjust color recognition pixel count zone during ACS recognition.)Increasing the setting value expands the recognition zone. 2ACS-EN2 ACS judgement area adjustment (with DF stream reading)Adjustment methodIncreasing the setting value increases the judgement range.Setting range: -2 to 2[Factory settings and after RAM clear: 1]2ACS-CNT2 Colour judgement pixel count area adjustment in ACS judgement (with DF stream reading)Adjustment methodIncreasing the setting value increases the judgement range.Setting range: -2 to 2[Factory settings and after RAM clear: 0]2REOS-PG REOS processing coefficient selection in 1200 dpiSetting range: 0 to 4[Factory settings and after RAM clear: 0] 2FEEDER>ADJUST (*1)Sub item Description level.DOCST Adjusting the Original Image Leading EdgeMethod of adjustmentA higher setting will delay the image leading edge timing.Range of adjustment-50 to 50 (unit: 0.1mm)[Factory default/After RAM clear:0]1LA-SPEED Adjusting the document feeding speed at the time of stream reading from the feederThe speed becomes faster (image is reduced) by increasing setting value.Range of adjustment: -30 to 30 (unit: 0.1%)[Factory default/After RAM clear:0] 1SORTER>ADJUSTSub item Description level.PNCH-HLE Adjustment of distance from sheet edges to punch hole positionsThis adjusts the hole positions to meet the conditions of the individual user.Setting range: -4 to 2 (in mm increments)[Factory setting/value after clearing RAM: 0]1COPIER>ADJUST>MISCSub item Description level.
