Chapter 44-24(For instance, if cards No. 1 through No. 1000 are used for group control,enter '1')2) Turn off and then on the machine; when the machine has started up, per-form the following in user mode:Select the following : user mode >system control settings >group IDcontrol >count control; then, check that IDs from 00000001 through00001000 have been prepared.Select the following : user mode >system control settings >networksettings >TCP/IP settings >IP address; then, set up 'IP address' 'gatewayaddress' and 'subnet mask'Select the following : user mode >system administrator setup; then, fill in'system control group ID' and 'system control ID No.' thereafter, turn offand then on the machine.If you leave out 'system control group ID' and 'system control ID No.' theservice engineer will not be able to 'register card to device' as part of setupwork for NSA.3) With the machine in standby state, download the card ID to be used fromNSA.4) When the card data has been downloaded from NSA, check that the IDdata has correctly been downloaded on the screen brought up by makingthe following selections:user mode>system control settings>group ID control(Only the downloaded ID data must be indicated.)5) Make copies using a user card registered with NSA, and check that statis-tical operations are made for the device in question.4.7.12 Controller Fan4.7.12.1 Before Removing the Controller Fan 0013-6789Color iR C3380G / Color iR C2880G / Color iR C3380i / Color iR C3380 /Color iR C2880i / Color iR C2880 / iR C3480 / iR C3480i / iR C3080 / iRC3080i / iR C25501) Detach the left rear cover. (page 10-17)[Detaching the Left Rear Cover]4.7.12.2 Removing the Controller Fan 0013-6792Color iR C3380G / Color iR C2880G / Color iR C3380i / Color iR C3380 /Color iR C2880i / Color iR C2880 / iR C3480 / iR C3480i / iR C3080 / iRC3080i / iR C25501) Remove the controller fan [1].- 1 connector [2]- 1 wire saddle [3]- 2 screws [4]F-4-41[1][4][2][4][3]
