4. Operation4.4 Overview of the menus on the device4.4.3 Menu ParameterThis submenu lists the function blocks that are being used in the current program. Thismakes it possible to change the values of constants in the program at runtime withouthaving to stop or re-transfer the program.When the password is activated and the +/- basic parameter for each function block isset, you can allow or deny the operator of the system the possibility to change the val-ues.Function blocks with basic parameters that you have set to + via the +/- character inthe function block editor are displayed in the PARAMETERS menu and can be changed.It is only possible to change constants. Other operands cannot be changed. It is alsopossible to change parameters via the PARAMETERS menu if you have saved the pro-gram and therefore password protected the function block editor.To immediately apply a change to the individual constants, press the OK button. Pressthe ESC button to cancel the change instead.List of function blocks inthe current program,e.g.,The current programdoes not use any func-tion blocksSTOP ✓ RUNPARAMETERSSET CLOCKCARDINFORMATIONSYSTEM-OPT.PROGRAMTable 12: ParameterT 01 Ü S +C 02L:1 STOPTable 13: ParameterCONTAINS NOFUNCTION BLOCKSTable 14: ParameterPressing the OK button will show the parameters for the individual function blocks in anadditional submenu that can be used to modify these parameters with the cursor but-tons.T 01 Ü S +>I1 000 800>I2 009 200QV> 000 000..Table 15: Time functionblock example96 easyE4 11/18 MN050009 EN www.eaton.com
