7. System settings7.8 Setting the startup behaviorThe RUN START option will be enabled by default on the EASY-E4-..., aswell as after a factory reset.What will happen if the program is deletedThe startup mode setting is a device function and will be retained even if the circuit dia-gram is deleted.Upload/download to memory card or PLCThe setting will be retained when a valid program is transferred.7.8.2 Enabling / disabling the CARD START optionThe mode for starting up with a memory card is intended for applications in which it isnecessary for it to be possible to change programs easily and quickly by changing thememory card.If the program on the memory card is different to the program in the easyE4 device, theprogram from the card will be loaded on power up first of all and then started in RUNmode. If the programs only contain different function block SETPOINT values (con-stants), the program on the memory card is not loaded.The program is retained in the device and is started. If there is no circuit diagram on thememory card the device will remain in STOP mode.Default setting CARD START inactive7.8.2.1 Configuration on a base device with a displayIn order to be able to configure this option, the program must be in STOP mode. If it isnot, the device will point this out.Go to the main menu.Go to SYSTEM OPTIONS\SYSTEM.Select the CARD START menu option.Press the OK button to enable and disable the option.If there is a checkmark ü next to the menu option, the program will be loaded from thememory card and applied as soon as the easyE4 device is switched on.If there is no check mark, the current program will be kept.7.8.2.2 Configuring the easySoft 7You can enable and disable this option in easySoft 7.Select the device you want from the catalog in the Project viewClick on the System settings tab.Go to the Memory card / device ID section and find the checkbox for Card start.To turn on, enable the checkbox by clicking on it.To turn off, disable the checkbox by clicking on it.easyE4 11/18 MN050009 EN www.eaton.com 467
