8. microSD memory card8.1 Automatic booting from the card8.1.3 Preparing the card for booting on the easyE4 device itselfPrerequisitesl The microSD memory card must contain at least one compiled PRG program.The easyE4 device must be in STOP mode before it can be configured. If it is not, thedevice will point this out.Insert the memory card while the device is de-energized.Switch on the supply voltage.Go to the main menu.Go to CARD.STOP ✓ RUNPARAMETERSSET CLOCKCARDINFORMATIONSYSTEM-OPT.PROGRAMTable 83: Main menuGo to PROGRAMPROGRAMLOG RECORDINGMANAGE SD CARDINFORMATIONTable 84: CardGo to START PROGRAMSET BOOT PROG.DELETE PROGRAMCARD -> DEVICEDEVICE -> CARDTable 85: Cards\ProgramSelect the starting program from the list containing the names of all the programsstored on the memory card.The ✓ checkmark at the end of a line indicates the program with which theeasyE4 device will start as soon as RUN mode is active.Name Program 1 ✓Name Program 2Name Program 3...Table 86: Card\Pro-gram\Set boot programIf the display is blank, this means that there are no pro-grams on the memory card.easyE4 11/18 MN050009 EN www.eaton.com 495
