7. System settings7.6 EthernetRemote RUNIf this field is enabled, the NET stations of a group with NET-IDs 02 through 08 will taketheir current RUN or STOP operating mode from the NET station with NET-ID 1.See also→ Section "Setting up a NET", page 5377.6 EthernetThis submenu can be used to configure the addresses for the easyE4 device.The other station must also be configured accordingly in order for it to be possible toestablish a connection.The last line on the status display will indicate whether there is an active connection.New easyE4 base devices will come with the Auto IP setting configured by default. Inorder to configure the settings differently on the EASY-E4-...-12...C1, use the menu struc-ture and go to System Options\EthernetThe submenu is only available in English.STOP ✓ RUNPARAMETERSSET CLOCKCARDINFORMATIONSYSTEM-OPT.PROGRAMTable 71: Main menuSECURITYSYSTEMMENU LANGUAGEDELETE PROGRAMNETETHERNETTable 72: System optionsADDRESS MODEIP ADDRESSSUBNET MASKGATEWAY ADDRESSDNS SERVERTable 73: System option-s\EthernetUse the cursor buttons to enter the device'sIP address. IP ADDRESS000.000.000.000Table 74: System Option-s\Ethernet\IP AddressSelect the network setting you want.AUTO IP ✓DHCPSTATIC IPTable 75: System Option-s\Ethernet\Address modeTable 70: Ethernet configuration on deviceSee also→ Section "Establishing an Ethernet connection", page 532464 easyE4 11/18 MN050009 EN www.eaton.com
