11. Connection to other devices11. Connection to other devicesNew easyE4 base devices will come with the Auto IP setting configured by default. Inorder to configure the settings differently on the EASY-E4-...-12...C1, use the menu struc-ture and go to System Options\EthernetSTOP ✓ RUNPARAMETERSSET CLOCKCARDINFORMATIONSYSTEM-OPT.PROGRAMTable 89: Main menuSECURITYSYSTEMMENU LANGUAGEDELETE PROGRAMNETETHERNETTable 90: System optionsADDRESS MODEIP ADDRESSSUBNET MASKGATEWAY ADDRESSDNS SERVERTable 91: System option-s\EthernetIP ADDRESS000.000.000.000Table 92: System Option-s\Ethernet\IP Address Use the cursor buttons to enter the device'sIP address.AUTO IP ✓DHCPSTATIC IPTable 93: System Option-s\Ethernet\Address mode Select the network setting you want.Table 88: Ethernet addresses on the devicePrerequisites that must be met in order to be able to access an easyE4 control relays:l The PC must have an Ethernet port that is free and has been configuredl The PC's Ethernet port must be configured for auto-IP.l The easyE4 control relays must be connected to the PC with a standard Ethernetcable featuring an RJ45 connectorCAUTIONINTERFERENCESThe values specified in the technical data, as well as the device's elec-tromagnetic compatibility (EMC), cannot be guaranteed if the followingare used: unsuitable cables, improperly assembled and terminatedcables, and/or wiring that does not conform to the applicable standards.Only use cables assembled and terminated by professionals.The cables being used must be assembled and terminated as requiredby the port/interface description in this document.When wiring the devices, follow all instructions regarding how to wirethe corresponding port/interface.All general Directives and standards must be complied with.easyE4 11/18 MN050009 EN www.eaton.com 521
