3. Commissioning3.3 Switch on3.3.2 Startup behavior of easyE4 control relays with a display and keypadIf there is no program, the control relay will start in STOP mode.All the information on the display will be shown in English if the device is configuredwith its factory settings.If there is an executable program on the easyE4 control relays, the device will start inRUN mode.In addition to having a valid program on the control relay,please make sure that there are no peripheral faults that willlead to STOP mode.easyE4 base device with integrated displayl If there is no splash screen on the memory cardafter being switched on, the easyE4 base device will showthe Eaton logo and then the status display. This status dis-play provides information on the device's status.l If there is a splash screen on the memory cardafter being switched on, the easyE4 device will show thesplash screen and then the status display. This status dis-play provides information on the device's status.If there is no executable program on the easyE4 control relays, the device will start inSTOP mode.All the information on the display will be shown in English if the device is configuredwith its factory settings. Once the device is ready for operation, the status display willappear.I 1 . . 4 . 7 8 . .N T 1 PMO 1 3 : 0 8Q 1 . . 4 R U NM A C : 0 0 2 2 C 7 1 2 3 4 3 E1 6 7 . 6 7 . 3 . 1Figure 46: Example of status display on display78 easyE4 11/18 MN050009 EN www.eaton.com
