3. Commissioning3.3 Switch on3.3.4 Status display on easyE4 control relays with display and keypadAfter being switched on, the easyE4 base device will start with the status display afterthe boot logo.The status display has six lines, with each one containing 16 characters.Press the Alt button to switch between displays.The first time you press ALT, the time will be replaced by the date.Pressing the ALT button again will switch to display 2Status indicator 1 Status indicator 2123456I 1 2 . . . 6 8 . . . E O KR E I N T 1 D C P -CO D h h : mAmAS Tq 1 2 3 . S T O PDevice nameIP Address1 2 3 4 5 6 7 8I D 1 - 8 :I D 9 - 16 :I D 17 - 24 :S T O PFigure 49: Start displays for easyE4 base device in EnglishStatus indicator 1Line 1 The Ethernet status for the base device without LED indicators will be shown for diagnostic purposesEOF The Ethernet port is not enabled;no Ethernet cable connected; supply voltage offThe port is not enabled; the easyE4 device does not have an IP addressECN Ethernet cable connectedEOK There is an Ethernet IP address, but the NET has not been configuredENW NET data flow working; all NET stations workingENM NET data flow working; one or more NET stations missingEER Ethernet conflict or error, e.g.: duplicate IP address, address collisionLine 2 Settings in current programRE Retention activeI Debounce activeNT NET stations with NET ID (1 this case)DC Used to display the type of power used by the base device (AC or DC)P P Buttons inactive (-) or active (+)Line 3 Current device settingWD Weekdayhh:mm Device time1xALT DD-MM-YYY Displays the device date with the configured formatST Configured startup behavior for the device;nothing displayed – automatic starting is possibleLine 4q Outputs; the number will be shown during activity (1, 2, 3, etc.)RUN/STOP Current device operating modeeasyE4 11/18 MN050009 EN www.eaton.com 81
