4. Operation4.5 Your first EDP program4.5.4 Delete programThe DELETE PROGRAM function not only deletes the circuit diagram but all elements ofa program. These are as follows:l Circuit diagraml Function block listl Function block diagraml ScreensThe system settings and operating parameters are reset to the default settings and alsoa possible NET parameterization.Proceed as follows to delete the program in the easyE4 device:easyE4 must be in STOP mode in order to extend, delete or modify the circuit diagram.Switch the easyE4 device to STOP mode.From the main menu, go to the SYSTEM OPTIONS menu.Opens additional menusSTOP ✓ RUNPARAMETERSSET CLOCKCARDINFORMATIONSYSTEM-OPT.PROGRAMTable 43: Main menuSECURITYSYSTEMMENU LANGUAGEDELETE PROGRAMNETETHERNETTable 44: System optionsDELETE PROGR.?YESNOTable 45: System options\Select DELETE PROGRAM.The easyE4 device will show a confirmation prompt.Select YES.Press the OK button to delete the programorPress the ESC button to cancelPressing the ESC button once more returns you to the previous menu level.easyE4 11/18 MN050009 EN www.eaton.com 113
