7. System settings7.8 Setting the startup behavior7.8 Setting the startup behaviorThe startup mode defines how the control relay will respond when the operatingvoltage is applied.EASY-E4-...-12...CX1Devices without a display can only be started in RUN mode.After power up, the easyE4 device switches directly to RUN mode if it contains a validprogram (circuit diagram). If, on the other hand, there is no circuit diagram in the device,it will remain in STOP mode.If the device is connected via Ethernet, it can be configured.EASY-E4-...-12...C1The startup behavior of devices with a display can be set.The selected startup mode is passed on with the program.Startup behaviorThe startup behavior is an important aid during the commissioning phase.The circuit diagram which EASY-E4-...-12...C1 contains is not yet fully wired up or thesystem or machine is in a state which EASY-E4-... is not permitted to control.If voltage is applied to the easyE4 device in this case, it should not be possible to drivethe outputs, i.e., it is not allowed for the outputs to be set immediately when the easyE4is switched on.7.8.1 Enabling / disabling the RUN START optionOnly possible on base devices with a display.7.8.1.1 Configuration on a base device with a displayIn order to configure it, the program must be stopped.STOP ✓ RUNOperating mode changes may be protected with a password.Go to the main menu.Go to SYSTEM OPTIONS\SYSTEM.Select the RUN START menu option.Press the OK button to enable and disable the option.Display StatusRUN START ✓ Active The program will start as soon as the device is switched on(the device will switch to RUN mode).RUN MODE Disabled The program will need to be started separately (the devicewill remain in STOP mode).466 easyE4 11/18 MN050009 EN www.eaton.com
