7. System settings7.15 Configuring the memory card and device ID7.15 Configuring the memory card and device IDOnly possible with easySoft 7.Select the device you want from the catalog in the Project viewClick on the System settings tab.Go to the Memory card / device ID section and look for the Card start checkbox, theAllow overwriting via card checkbox, and the numeric input field.To turn on, enable the checkbox by clicking on it.To turn off, disable the checkbox by clicking on it.If Card start, the device will access the memory card when it is switched on.If Allow overwriting via card, it will be possible for theprogram that is found on the memory card to overwrite the program stored on theeasyE4.You can enter a six-digit number as a Program/device ID into the input field.This ID ensures that a program will be overwritten on theeasyE4 device only if the IDs match.See also→ Section "Transferring programs from and to a memory card", page 150→ chapter "7 microSD memory card", page 487easyE4 11/18 MN050009 EN www.eaton.com 481
