11. Connection to other devices11.1 Functions offline11.1.3 Wiring testThe base device must be connected to easySoft online and be in STOP mode.The status display must be on.Either click on the Wiring test on/off option in the Communication menu or click onthe Wiring test button in the toolbar.Select the device for which you want to run the wiring test (base device or expan-sion device)The input states will be displayed and, for each output, there will be a switch that youcan use to switch the output on and off.WARNING! AUTOMATIC STARTUP!If you are running a wiring test with the outputs, make sure that thisdoes not result in the system or machine assuming a dangerous state.Do not, under any circumstance, leave your programming devicewithout first turning off the wiring test.Use the wiring test only if you are sure that you will always know whatthe response will be when switching outputs on and that this will notendanger any people or property.Do NOT use the wiring test with outputs remotely through a network.Make absolutely sure than your actions do not put people or property atrisk.Either click on the Wiring test on/off option in the Communication menu or click onthe Wiring test button in the toolbar to turn the test off.All outputs are switched off.Terminating communications with the base device will also switch off all outputs.Make sure that the wiring test is off and that all outputs have a state of "OFF."11.1.4 Group diagnostic alarmsEither click on the Group diagnostics option in the Communication menu orclick on the Group diagnostics button in the toolbar.You will get a log message containing all the diagnostic alarms in the device.easyE4 11/18 MN050009 EN www.eaton.com 531
