4. Operation4.1 Base device with display and buttons4.1.4 Cursor displayThe cursor buttons in the easyE4 program perform three functions:l Movel Enterl ConnectThe current mode is indicated by the appearance of the flashing cursor.Current selection flashes on the easyE4 displayœ In Move mode, use to position the cursor on the circuit diagramin order to select a rung, a contact or a relay coil orthe selection position of a coil function or a NET-ID.I 01 Use the OK button to switch to Entry mode so that you can enter or change a valueat the current cursor position.Press the ESC button in Entry modeto restore to the last changes of an entry.l Press the ALT button to switch to Connect mode for wiring contacts and relays.Press the ALT button again to return to Move.ESC Press the ESC button to leave the program (circuit diagram and parameter display).4.1.5 Entering of valuesUsed to select a position.Use to select valuesand/or a settingESC Cancel, retain previous valueOK Store settings90 easyE4 11/18 MN050009 EN www.eaton.com
