4. Operation4.6 Transfer program to the easyE4 device4.6.2 Establish Ethernet connectionEstablishing a connection between a PC and an easyE4 base deviceIn order to be able to establish a connection, your PC must first have the required Eth-ernet capability. This capability can be in the form of a local Ethernet port on the PC or astandard adapter (e.g., USB-to-Ethernet adapter).The PC's and the easyE4 base device's IP addresses must fall within the same range,i.e., the addresses' first two or three numbers must be the same, while the last numbermust be different and not equal to 0.Check the easyE4 device's IP address.To do this, open the INFORMATION\ACTUAL CONFIG menu and scroll to IPADDRESS.STOP ✓ RUNPARAMETERSSET CLOCKCARDINFORMATIONSYSTEM-OPT.PROGRAMTable 46: Main menuACTUAL CONFIGSYSTEMTable 47: InformationNET-GROUP: 00NET-ID: 00MAC ADDRESS:xxxxxxxxxxxxDEVICE NAME:IP ADDRESSxxx.xxx.xxx.xxxSUBNET MASK000.000.000.000GATEWAY ADDRESS000.000.000.000DNS SERVER000.000.000.000WEB SERVER: ✓HTTP PORT:MODBUS TCP:KEEPALIVE: 0060Table 48: Information\Actual ConfigIf an IP address has not been assigned yet, enter one.To do this, open the SYSTEM OPTIONS\ETHERNET\IP Address menu.STOP ✓ RUNPARAMETERSSET CLOCKCARDINFORMATIONSYSTEM-OPT.PROGRAMTable 49: Main menuSECURITYSYSTEMMENU LANGUAGEDELETE PROGRAMNETETHERNETTable 50: System optionsADDRESS MODEIP ADDRESSSUBNET MASKGATEWAY ADDRESSDNS SERVERTable 51: System option-s\EthernetIP ADDRESS000.000.000.000Table 52: System Option-s\Ethernet\IP Address Use the cursor buttons to enter the device'sIP address.easyE4 11/18 MN050009 EN www.eaton.com 119