5. Programming on the device5.4 Working with contacts and coils5.4.3 Entering and modifying coilsWith a relay coil or a function block, you choose the coil function, coil name, coil numberas well as the function block coil. With coils of an NET station, choose the address (NETID) in front of the coil name.The coil number in the figures on the left must be the same asthe function block number!ExamplesFigure 80: Relay coil "Out-put Q"Figure 81: Relay coil for timing relayfunction block with control coilFigure 82: Relay coil of aNET stationA complete list of all contacts and coils,→ Section "Function blocks", page 166The values for contact and coil fields can be changed in input mode.The value that can be changed will flash.The easyE4 device proposes contact I 001 or the coil Ä Q001 for entry in an empty field.Use the buttons to move the cursor to a free contact or coil field.Press the OK button to switch to Entry mode.Use to select the position you wish to change and press the OK to move tothe next position(a selected position is shown in light grey in the following figure).Use the cursor buttons to change the value at the position.The easyE4 device will exit input mode as soon as you exit a contact or coil field withthe cursor buttons or the OK button.136 easyE4 11/18 MN050009 EN www.eaton.com
