152 Planning the Nortel WLAN 2300 SystemNN47250-102 (320666-G Version 02.01)• To list access on other floors that can be detected from this RF measurement point, select ShowAPs on Other Floors.See “Reading the RF Measurement Table” (page 152) for information about the fields in the display.7 Click OK to save the changes and close the box.8 Do one of the following:• To use the RF interactive measurement mode, see “Using RF Interactive Measurement Mode”(page 152).• To generate network design information, see “Generating RF Network Design Information”(page 154).• Click Finish to save the changes and close the wizard.Using RF Interactive Measurement ModeRF interactive measurement mode is useful when you are troubleshooting or surveying the coverage areas on the floor.You can quickly measure signal strengths for any location on the floor.To use the RF interactive measurement mode1 Click the icon in the toolbar.2 Click any location on the floor. Received signal strength indication (RSSI) measurements for the selectedlocation appear next to the Floor View. See “Reading the RF Measurement Table” (page 152) forinformation about the fields in the display.Reading the RF Measurement TableThe projected signal strengths for the planned equipment from that measurement point are shown in the RF measure-ment table.X-Y coordinates for the measurement point and display options are also available to customize the RSSI table. Usingthis interactive mode can be valuable when verifying deployment coverage with a portable WLAN measurement tool onthe floor.
