Configuring WSS System Parameters 173Nortel WLAN—Management Software 2300 Series Reference GuideLaunching a Web View Management Session with the Switch1 Select the Configuration tool bar option.2 In the Organizer panel, select the WSS.3 In the Task List panel, select Launch Browser.Viewing and Changing Port SettingsYou can configure and display information for the following port parameters:• Name• State• Type (network, AP, or wired authentication)• Speed and autonegotiation• Power over Ethernet (PoE) state• Media type (gigabit Ethernet ports only)• Load sharing (see “Viewing and Changing Port Groups” (page 180))Viewing Port Settings1 Select the Configuration tool bar option.2 In the Organizer panel, click the plus sign next to the WSS.3 Click the plus sign next to System.4 Select Ports.The ports and their configuration settings appear in the Content panel. The 10/100 Ethernet ports and thegigabit Ethernet ports (if the switch has them) are listed separately.Changing Port SettingsTo change settings for a port, edit the row of information for the port.1 In the Name box, type a name for the port (1 to 16 alphanumeric characters, with no spaces or tabs).2 To enable the port, select Enabled. To disable the port, clear Enabled. By default, the port is enabled.3 To specify the speed of a 10/100 Ethernet port, select one of the following:Note. This option is available only if the switch is running and can be reached throughthe network by WLAN Management Software Services. This option also requires theManaged option for the switch to be enabled. (See step 6 in “Modifying Basic SwitchParameters” (page 168).)
