Configuring WSS System Parameters 169Nortel WLAN—Management Software 2300 Series Reference Guide7 To modify the management interface, select the IP interface and VLAN from the VLAN/IP drop-downlist.8 To modify the enable password, edit the string in the Enable Password box.9 To change the switch’s Mobility Domain membership, select the Mobility Domain from the MobilityDomain drop-down list.To leave the switch out of all Mobility Domains, select Not Assigned.10 To change the switch’s wiring closet membership, select the closet from the Wiring Closet drop-downlist.To leave the switch out of all wiring closets, select Not Assigned.11 Click Save.Changing the WSS Software Version1 Select the Configuration tool bar option.2 In the Organizer panel, select the WSS.3 In the Task List panel, select Software Version.The Change Software Version wizard appears.4 Select the software version from the drop-down list.5 Click OK.Changing the WSS Model1 Select the Configuration tool bar option.2 In the Organizer panel, select the WSS.3 In the Task List panel, select Model.Caution! After you select Managed to enable management of the switch byWLAN Management Software, do not change this option unless advised to do soby NETS. If you change a WSS to an unmanaged state in a network plan, allnetwork operations (polling) stop for that WSS. If you change back to a managedstate, the entire configuration of the switch is replaced with the settings from thenetwork plan, which can result in loss of connectivity to the switch.Note. Use this option when you are creating a new switch in WLANManagement Software. This option modifies the password in the network plan.However, if the switch is already deployed in the network, WLAN ManagementSoftware cannot apply configuration changes to the switch unless the enablepassword in WLAN Management Software matches the enable password alreadyconfigured on the switch.
