168 Configuring WSS System ParametersNN47250-102 (320666-G Version 02.01)b To change the radio type the profile assumes for 802.11b/g radios in dual-radio AP models, selectthe radio type from the AP Radio Type drop-down list:❍ 11b❍ 11g11 Click Finish.Modifying Basic Switch ParametersBasic switch parameters are displayed in the Content panel when you select a switch in the Organizer panel.1 Select the Configuration tool bar option.2 In the Organizer panel, select the WSS.Basic parameters for the switch appear in the Content panel.3 To modify the name, edit the string in the WSS Name box.4 To modify the serial number, edit the string in the Serial Number box.5 To modify the system IP address and VLAN, select them from the System VLAN/IP drop-down list.The system IP address determines the interface or source IP address WSS Software uses for system tasks,including the following:• Mobility Domain operations• Topology reporting for dual-homed APs• Default source IP address used in unsolicited communications such as AAA accounting reportsand SNMP notifications6 To enable the switch to be managed by WLAN Management Software, select Managed. Until this optionis selected, you cannot deploy the switch configuration you create in WLAN Management Software tothe actual switch in the network.Note. Modification of the serial number applies only when you are prestaging aspecific switch. This option does not change the serial number of an installedswitch.Note. This option also enables the Launch Telnet and Launch Browser optionsin the Task List panel.
