468 Changing WLAN Management Software Services PreferencesNN47250-102 (320666-G Version 02.01)To change monitoring settings1 Select Services > Setup or select the browser window if WMS Services is already open. (See Figure 1 onpage 458.)1 Select Tools > WMS Services Setup. The WMS Services Setup dialog box appears. (See Figure 1 onpage 458.)2 Select Setup, then select Monitoring Settings.3 Click the Monitoring Settings tab.4 To change the number of minutes between status queries from WMS Services to the WSSs it monitors,change the value in the Polling interval box. You can specify from 1 to 60 minutes. The default is 5minutes.5 To change settings for monitoring of the log buffers on WSSs:a Select Enable Log Monitoring. This option is enabled by default.b To change the number of minutes between queries of the switches’ log buffers, change the value inthe Polling interval box. You can specify from 1 to 60 minutes. The default is 5 minutes.c To change the maximum number of log entries WMS Services stores for an individual WSS, changethe value in the entries per WSS box. You can specify from 1000 to 5000 entries, in increments of100. The default is 1000 entries.6 To change settings for client-session data collection:a Select Enable Client Session Collection. This option is enabled by default.b To change the number of minutes between data queries, change the value in the Polling interval box.You can specify 5, 10, or 15 minutes. The default is 5 minutes.7 To change settings for traffic and RF data collection:a Select Enable Traffic & RF Trending. This option is enabled by default.b To change the number of minutes between data queries, change the value in the Polling interval box.You can specify 5, 10, or 15 minutes. The default is 5 minutes.8 To change settings for Intrusion Detection System (IDS) and Denial of Service (DoS) data collection:a Select Enable Rogue Detection. This option is enabled by default.b To change the number of minutes between data queries, change the value in the Polling interval box.You can specify 5, 10, 15, or 30 minutes. The default is 5 minutes.9 Click Save to save the changes.10 To enable data collection for client sessions, select Enable Client Session Collection. This option isenabled by default.11 To enable RF data collection, select Enable Traffic & RF Trending. This option is enabled by default.Note. The Polling Interval is 5 minutes and cannot be changed.Note. The Polling Interval is 5 minutes and cannot be changed.
