Link Layer ProtocolDescriptionUsing the ppp mp max-receive-frags command, you can configure the maximumnumber of fragments received by the MP channel. Using the undo ppp mpmax-receive-frags command, you can restore to the default value.MP allows a data packet to be fragmented so that they can be sent over different linksto the destination. These fragments will be reassembled to form a complete packet atthe destination.The maximum number of fragments received should not be less than that of fragmentssent by the other end of the MP channel. When the maximum number of fragmentsreceived is set to 1, it means that the fragment packet will not be received.After the parameter frags is modified, MP channel must be re-established to make theconfiguration take effect.To re-establish the MP channel, disable all the PPP links bound in MP channel with theshutdown command and then enable these links one by one with the undo shutdowncommand.For related commands, see ppp mp max-bind, ppp mp max-send-frags, ppp mpuser, ppp mp.Example# Set the maximum number of fragments received by a MP channel to 5.[3Com]ppp mp max-receive-frags1.1.14 ppp mp max-send-fragsSyntaxppp mp max-send-frags fragsundo ppp mp max-send-fragsViewSystem viewParameterfrags: Maximum number of fragments sent by a MP channel, ranging 1 to 10. Thedefault value is 1.DescriptionUsing the ppp mp max-send-frags command, you can configure the maximumnumber of sending fragments that MP channel allows. Using the undo ppp mpmax-send-frags command, you can restore the maximum number of sendingfragments that MP channel allows to default value.17
