Link Layer Protocolinterface-number: Interface numberDescriptionUsing the bridge mac-address command, you can configure a static address tableentry of bridge. Using the undo bridge mac-address command, you can cancel thestatic address entry.By default, no static address is configured.Normally, an address table is generated according to the relations of the MACaddresses obtained by the bridge. However, there are still some static address entriesin the bridging address tables, which are manually configured and maintained byadministrators and will never become aged.Example# Enable the interface Ethernet 0 to forward the frames with the MAC address00-00-00-00-01-11.[3Com]bridge 1 mac-address 00-00-00-00-01-11 permit Ethernet 08.1.7 bridge routingSyntaxbridge bridge-set routing { ip | ipx }undo bridge bridge-set routing { ip | ipx }ViewSystem viewParameterbridge-set: Bridge set number in the range of 1 to 63.ip: Internet Protocol.ipx: Internet Packet Exchange Protocol.DescriptionUsing the bridge routing command, you can enable a specified bridge set to route anetwork layer protocol. Using the undo bridge routing command, you can disable thespecified bridge set to route the protocol.By default, routing function of bridge set is disabled.If a bridge is configured to route a network layer protocol, it will route the packets of theprotocol that require routing.147
