Link Layer ProtocolExample# Disable the bridging function.[3Com]undo bridge enable8.1.4 bridge learningSyntaxbridge bridge-set learningundo bridge bridge-set learningViewSystem viewParameterbridge-set: Bridge set number in the range of 1 to 63.DescriptionUsing the bridge learning command, you can enable forwarding by using dynamicaddress table. Using the undo bridge learning command, you can disable using thedynamic address table to forward, i.e., merely using the static port table to forward.By default, forwarding is enabled by using dynamic address table.The dynamic address table does not require manual maintenance. It can automaticallyrefresh whenever the network topology takes changes.Example# Enable the interface Ethernet 0 to use the dynamic address table to forward.[3Com]bridge 1 learning8.1.5 bridge link-set originSyntaxbridge bridge-set link-set link-set originundo bridge bridge-set link-set link-set originViewSystem viewParameterbridge-set: Bridge set number in the range of 1 to 63.link-set: Link set number in the range of 1 to 9.145
