3Com Router Command Reference Guide — V1.008.1.22 bridge-set stp disableSyntaxbridge-set bridge-set stp disableundo bridge-set bridge-set stp disableViewInterface viewParameterbridge-set: Bridge set number, in the range of 1 to 63.DescriptionUsing the bridge-set stp disable command, you can disable STP on a port. Using theundo bridge-set stp disable command, you can enable STP on the port.By default, STP is enabled on ports.Only when the interface STP is enabled can all the configured parameters related to theSTP take effect.Example# Disable STP on Ethernet0.[3Com-Ethernet0]bridge-set 1 stp disable8.1.23 bridge-set stp port pathcostSyntaxbridge-set bridge-set stp port pathcost costundo bridge-set bridge-set stp port pathcostViewInterface viewParameterbridge-set: Bridge set number, in the range of 1 to 63.cost: Path cost of a bridge port, in the range of 1 to 65535. By default, the path cost ofEthernet port is 100 and the path cost of serial interface is 647.DescriptionUsing the bridge-set stp port pathcost command, you can configure a path cost for abridge port. Using the undo bridge-set stp port pathcost command, you can restorethe default path cost of the bridge port.158
