Routing ProtocolViewInterface viewParameter1: RIP Version 1.2: RIP Version 2.multicast: Supports RIP-2 broadcast packet.multicast: Supports RIP-2 multicast packet.DescriptionUsing the rip version command, you can configure the RIP version working on aninterface. Using the undo rip version command, you can restore the default versionworking on an interface.RIP-1 is the default version used on the interface. When RIP-2 is used on theinterface, multicast is the default mode.RIP-2 has 2 transmission modes: broadcast and multicast. Multicast is the defaultmode. The multicast address in RIP-2 is 224.0.0.9. One of the advantages ofmulticast mode is that the hosts that do not run RIP in this network will not receive thebroadcast packets. Additionally, hosts running RIP-1 will be prevented from receivingand processing the RIP-2 routes with subnet masks.When the interface specifies the use of RIP-1, only RIP-1 and RIP-2 broadcastpackets will be received. In this case, RIP-2 multicast packets will be rejected. Whenthe interface is specified to use RIP-2 multicast, only RIP-2 multicast packets andRIP-2 broadcast packets will be received. In this case, RIP-1 packets will be rejected.Example# Set Serial 0 supports RIP-2 broadcast packets.[3Com-Serial0] rip version 2 broadcast2.1.23 rip workSyntaxrip workundo rip work31
