System ManagementIf not specified, the above parameters are set as follows:z Number of times that the IPX ping packet request is sent: 5 times.z Timeout for the IPX ping reply packet: 2s.z The size of the IPX ping request packet: 100 bytes.The ping ipx command can be used to test if the IPX network is faulty. The outputincludes:z Reply to each IPX ping packet request from the destination. If no reply isreceived within the timeout limit, then “!” is output, otherwise “.” is shown.z Final statistics, including the number of packets sent, the number of replypackets received, the percentage of packets unanswered, the minimum, themaximum and the average value.Example# Check if the host whose IPX address is 2.0.0c91.f61f is reachable.[3Com] ping ipx 2.0.0c91.f61fPress CTRL_C to breakSending 5, 100-byte IPX Echoes to 2.0.0c91.f61f, timeout is 2 seconds!!!!!--2.0.0c91.f61f IPX ping statistics--5 packets transmitted5 packets received0% packet lossround-trip min/avg/max = 1/2/3 ms4.2.3 tracertSyntaxtracert [ -a ip-address ] [ -f first_TTL ] [ -m max_TTL ] [ -p port ] [ -q nqueries ] [ -wtimeout ]tracert ip-addressViewAll viewsParameter-a ip-address: Used to test whether or not –a switch is correct and to specify a sourceaddress to which the IP packets are sent.-f: To test if the –f switch is correct.71
