System ManagementParameterNoneDescriptionUsing the send switch command, you can enable/disable a terminal to receivemessages from other terminals.By default, a terminal is enabled to receive the messages from other terminals.In terminal message service, whether to receive messages from other terminals isdecided by the send switch command. If the terminal message service is currentlyenabled, it will be disabled after a second input of this command.For related commands, see send status.Example# Display the status of the terminal for receiving messages from other terminals (theterminal was enabled to receive the messages).[3Com] send switch2.3 Dumb Terminal Service Configuration Commands2.3.1 auto-execute commandSyntaxauto-execute command commandundo auto-execute command commandViewAsynchronous serial interface viewParametercommand: An entire command line.DescriptionUsing the auto-execute command command, you can configure the command to beexecuted automatically on the asynchronous serial interface. Using the undo25
