Reliabilitypriority: Priority of the standby logic channel, ranging 0 to 255, being 0 by default. Thegreater the value is, the higher the priority is.DescriptionUsing the standby logic-channel command, you can configure a certain logicchannel as a standby interface. Using the undo standby logic-channel command,you can cancel the specified standby interface.By default, no standby interface is specified.The logic channel is an X.25 virtual channel, frame relay virtual circuit or Dialer Route.Before a standby logic channel is specified for a main interface, it is necessary tomatch this logic channel number to the specific virtual circuit or Dialer Route.For related commands, see logic-channel, standby interface.Example# Specify logic channel 2 as the standby interfaces for Serial 0, whose priority value is30.[3Com-Serial0]standby logic-channel 2 301.1.5 standby state-downSyntaxstandby state-down timesundo standby state-downViewLogic channel viewParametertimes: Number of calls, ranging 0 to 65535, being 0 by default.DescriptionUsing the standby state-down command, you can configure the number of callsused to detect whether the logic channel is down. Using the undo standbystate-down command, you can cancel the existing setting.If the logic channel continuously originates a number of calls (numbered times) andalways fails, the state of logic channel is considered to be down. In this case, if the5
